Advance Training Course on (CCNA)
Advance Training Course on (CCNA)
Course Outline
CCNA 1 – Introduction to Networks
- Network basic
- Network models
- OSI Model
- TCP/IP Model
- Ethernet Technology
- IP Addressing
- Subnetting IP Networks
- VLSM
- Cisco IOS overview
- Configuring a Network Operating System
CCNA 2 – Routing Essentials
- Routing Concepts
- Static Routing
- Routing Dynamically
- Routing Information Protocol ( RIP)
- Enhance Interior Gateway Routing Protocol (EIGRP) Open Shortest Path First (OSPF)
- Single Area OSPF
- Multiarea OSPF
- Access Control List
- Dynamic Host Configuration Protocol (DHCP)
CCNA 3 – Switching Essentials and Scaling Networks
- Basic Switching Concepts and Configuration
- VLANs
- Inter-VLAN Routing
- Spanning Tree Protocol (STP)
- Rapid Spanning Tree Protocol (RSTP)
- Per-VLAN Spanning Tree (PVST)
- LAN Redundancy
- Hot Standby Router Protocol (HSRP)
- Virtual Router Redundancy Protocol (VRRP)
- Gateway Load Balancing Protocol (GLBP)
- Link Aggregation
- Wireless Networks
CCNA 4 – Connecting Networks
- Hierarchical Network Design
- Connecting to the WAN
- Network Address Translation (NAT)
- Point to Point connection
- Frame Relay
- Troubleshooting the Network
- IPv6
Lab 1 : Logging into a Router & Introduce with cisco IOS and its features
Lab 2 : Basic Router configuration and configuring line console, Telnet, SSH
Lab 3: Configuration back up & restoring the configuration and password recovery
Lab 4: IOS up gradation by USB, TFTP and IOS up gradation in Rommon mode
Lab 5: Configuring and verifying Static route and RIP
Lab 6: Configuring and verifying EIGRP
Lab 7: Configuring and verifying OSPF
Lab 8: Basic Switch configurations
Lab 9: Configuring VLANs, Trunk Ports, and Inter-VLAN Routing
Lab 10: Configuring Dynamic Host Configuration Protocol
Lab11: Configuring HSRP, VRRP, GLBP
Lab 12: Configuring Access List
Lab 13: Configuring Network Address Translation
Lab14: Configuring Wireless Devices
Lab 15: Configuring Point - to - Point Connection
Lab 16: Configuring Frame relay